Siemens HiPath 1130 - Sensor Activation Logic; Time between Attempts for Activating the Sensor

Step by Step
Relay and Sensor on the HiPath 1120
128
= Deactivate the sensor’s function (default)
= Dial the number specified in "Number Dialed by
Sensor Activation" (Code 052).
= Activate the relay through the sensor
= Detect DTMF code. When this setting is selected,
the number that was called must acknowledge or
ignore an alarm call by sending an acknowledge-
ment code (“#” DTMF signal )
Press this key.
Initial state for Programming Mode.
Sensor Activation Logic
The sensor’s main position can be set as follows:
• Contacts are closed. The sensor is activated when
contacts are open.
• Contacts are open. The sensor is activated when
contacts are closed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select the main position for the sensor:
= Contacts closed (default)
= Contacts open
Press this key.
Initial state for Programming Mode.
Time between Attempts for Activating the
Sensor
This setting specifies a timeout after which a new
attempt is made to call an internal or external number,
assuming that the line was busy on the previous
attempt.
The default setting is 3 minutes.
Required: Programming Mode must be active (*95
31994).
0
1
2
3
#
7 4
0 1
0
1
#