Siemens HiPath 1130 - Call Charge Value by Extension; Call Cost Limit for an Extension

Step by Step
General Programming
84
Press this key.
Initial state for Programming Mode.
Call Charge Value by Extension
This setting specifies the monthly amount that each
extension can spend.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
Enter the maximum amount that can be spend by the
extension (up to 5 digits)
... Enter the decimal separator position (0 to 4)
For example, for $ 0.12: 00012 and 2
For example, for $ 1.00: 00001 and 0 (default).
Initial state for Programming Mode.
Call Cost Limit for an Extension
This setting limits how much an extension has available
for Call Charges.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
or Activate/Deactivate Call Charge limit:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
#
9 7
0 4
4 40
*
#
*
#