Siemens HiPath 1130 - Date for Updating the Call Cost Limit for an Extension; Updating the Software; SW Information

General Programming
85
Step by Step
Date for Updating the Call Cost Limit for an
Extension
This specifies a day for resetting the Call Charge limit.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a day for resetting the limit (01 to 31).
or
To deactivate
Initial state for Programming Mode.
Updating the Software
SW Information
This displays information about the system’s software.
To view this information use a system telephone with a
display.
Required: Programming Mode must be active (*95
31994).
Enter the programming code to view the name of the
product, e.g., "HiPath 1150.
Press the key to view additional information:
1) Release
2) Version
3) APS
4) Serial number
Press this key.
Initial state for Programming Mode.
4 50
d d
*
If 31 is entered, the Call Charge limit will be reset
to the last day of each month.
0 0 1
*
#