Siemens HiPath 1130 - External Number for Updating the Software; Frequency for SW Update

General Programming
87
Step by Step
The default setting specifies the time for the update
process at 00:00 hours.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
: Enter the hour (00 to 23) and the minutes (00 to 59) for
starting the update.
Initial state for Programming Mode.
External Number for Updating the Software
This setting specifies a number to be used by the
system to update the software.
The default configuration does not specify any number.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the external numbers (up to 20 digits).
Press this key to finalize the entry.
Initial state for Programming Mode.
Frequency for SW Update
This setting specifies regular intervals for transferring
data, in months. During a transfer the telephone
operates as usual.
The default setting specifies updates to be done in a
monthly basis.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter a timeout for the update (01 to 12) where 01 =
update every month (default) 12 = update every 12
months at a specified date.
Initial state for Programming Mode.
0 5 8
h h m m
0 5 6
#
0 5 7
0 1 1 2