Siemens HiPath 1130 - Remote MSN; Without MSN Verification; Remote Administration Via DTMF

General Programming
95
Step by Step
... Select a slot for the external number (1 to 4).
Enter a password (5 digits).
... Select the next external number
or
Press this key.
Initial state for Programming Mode.
Remote MSN
This setting specifies an MSN of your ISDN line as the
Remote Administration MSN.
The default configuration does not specify a MSN.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot (001... 140) for the MSN
or
Press the key to remove it.
Initial state for Programming Mode.
Without MSN Verification
Remote Administration will be performed without
verifying the Service MSN transmitted.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Activate/Deactivate:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
Remote Administration via DTMF
With this feature you can configure the HiPath 1100
remotely with an MF telephone.
1 4
1 4
#
0 6 9
0 1
0
4 01
*
0 7 0
*
#
*
#