Siemens HiPath 4000 - More functions;services; Using another telephone in the same way as your own; Logging on to another phone

Additional functions
99
PC interface (V24, USB)
You can use the PC interface (via a Slim Lumberg cable) to read and modify
phonebook entries, pictures and sounds.
Configuring the PC interface
To configure the PC interface, you must:
1. deactivate the Bluetooth interface on the handset (Æ Page 102).
2. use a Siemens data cable (Æ Page 112) to connect the headset/PC in-
terface jack on the handset to the computer.
3. install the MPM application.
For more information, consult your system administrator.
Data transfer mode
Large volumes of data are transferred between the handset and the com-
puter for certain functions. In this case, the handset is switched to data
transfer mode and data transfer appears on the display. In this mode, no
inputs are possible via the keyboard and calls are ignored.
The handset is switched to data transfer mode by:
• activating read/write access to the phonebook
• loading screensavers
• loading melodies
Note:
If the PC interface does not work, first deactivate the Bluetooth in-
terface (Æ Page 102), then switch the handset off and back on.
Note:
The handset automatically switches to idle if a fault occurs in the
course of transferring data.