Siemens HiPath 500 - Answering Calls with the Trunk Keys; Dialing with Trunk Keys; Placing a Call on Hold on a Trunk Key and Retrieving the Held Call

Making calls in the team/executive/secretary configuration
105
Step by Step
Answering calls with the trunk keys
Prerequisite: Your telephone rings or the trunk key
flashes quickly.
if nec.
T Press the trunk key that is flashing quickly.
(not necessary if "Prime Line" is active).
^ Lift the handset.
or On-hook dialing: Speakerphone mode.
Dialing with trunk keys
if nec. S Press the free trunk key you wish to use to establish the
connection
(not necessary if "Prime Line" is active).
j Dial the phone number.
^ If the party does not answer: Lift the handset.
or On-hook dialing: Speakerphone mode.
Placing a call on hold on a trunk key and
retrieving the held call
Prerequisite: You are conducting a call via one of your
group’s trunks. The "Hold" key has been programmed
on your telephone Æ page 72.
Hold
S Press the "Hold" key.
if nec.
\ or s Replace the handset or press the disconnect key.
Depending on the configuration (contact your service
personnel), this may be necessary so other team mem-
bers can also pick up the call on hold.
Retrieving the call
T Press the trunk key flashing slowly.