Siemens HydroRanger 200 HMI - Vessel Shape (2.7.2.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
186 Operating Instructions, 06/2018, A5E36281317-AC
8.6.7.2
Vessel shape (2.7.2.)
Enters the Vessel Shape value matching the monitored vessel or wet well.
Liquid (material) volume is calculated when Sensor Mode (2.1.3.) (Page 163) = *Level.
Alternatively, the remaining vessel capacity is calculated when Sensor Mode (2.1.3.)
(Page 163) = Space. In RUN mode, readings are displayed in percent of maximum volume.
To convert readings to volumetric units, see Maximum Volume (2.7.3.) (Page 188).
Vessel shape
Display/description
None
* NONE
Flat level bottom
Flat ends
Parabolic bottom
Half sphere bottom
Flat sloped bottom
Parabolic ends