Siemens HydroRanger 200 HMI - Dimension L (2.7.5.); Transducer Selector (2.7.6.); Inflow;Discharge Adjust (2.7.7.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
189
8.6.7.5
Dimension L (2.7.5.)
Enters the length of the cylindrical section of a horizontal parabolic end vessel. For
illustrations, see Vessel shape (2.7.2.) (Page 186).
Dimension L as used in Vessel shape (2.7.2.) (Page 186).
Index
Level
Values
Range: 0.000 ... 99.000 m or equivalent, depending on Units (2.1.1.) (Page 162)
Preset: 0.000
Related
Vessel shape (2.7.2.) (Page 186)
Enter the tank length (excluding both end sections) if Vessel shape (2.7.2.) (Page 186) =
parabolic ends.
8.6.7.6
Transducer selector (2.7.6.)
Sets the transducer index for all parameters applicable to this sub-menu.
8.6.7.7
Inflow/discharge adjust (2.7.7.)
The method used to calculate the volume pumped, for pumped total [Sensor Mode (2.1.3.)
(Page 163) = Pump Totalizer].
Index
Single-point model
Dual-point model
Global
Transducer
Options
Based on Pump Cycle
No adjustment
*Based on Rate Estimation
Related
• Sensor mode (2.1.3.) (Page 163)
• Rate filter (2.3.5.) (Page 175)
• Rate filter time (2.3.6.) (Page 175)
• Rate filter distance (2.3.7.) (Page 175)
• Rate (2.3.) (Page 172)