Siemens HydroRanger 200 HMI - Measurement Verification (2.11.5.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
233
2.11.4.4. Brkpt. 31-40
2.11.4.4.1. TVT Brkpt. 31
2.11.4.4.2. TVT Brkpt. 32
2.11.4.4.3. TVT Brkpt. 33
2.11.4.4.4. TVT Brkpt. 34
2.11.4.4.5. TVT Brkpt. 35
2.11.4.4.6. TVT Brkpt. 36
2.11.4.4.7. TVT Brkpt. 37
2
.11.4.4.8. TVT Brkpt. 38
2.11.4.4.9. TVT Brkpt. 39
2.11.4.4.10. TVT Brkpt. 40
8.6.11.5
Measurement verification (2.11.5.)
Transducer selector (2.11.5.1.)
Sets the transducer index for all parameters applicable to this sub-menu.
Up sampling (2.11.5.2.)
Sets the number of consecutive echoes that must occur above the echo currently locked
onto before the measurements are validated as the new reading [for Echo Lock (2.11.5.4.)
(Page 235) = Maximum verification or Material agitator].
Index
Single-point model
Dual-point model
Global
Transducer
Values
Range: 1 ... 50
Preset: 5
Related
• Echo lock (2.11.5.4.) (Page 235)
• Down sampling (2.11.5.3.) (Page 234)
Echo Lock (2.11.5.4.) (Page 235)
Up Sampling value
Maximum verification
5
Material agitator
5
For more details, see Down sampling (2.11.5.3.) (Page 234).