Siemens HydroRanger 200 HMI - Pump Records (3.2.9.)

Parameter reference
8.7 Maintenance and Diagnostics (3.)
HydroRanger 200 HMI
260 Operating Instructions, 06/2018, A5E36281317-AC
mA input (3.2.8.19.)
Displays the mA input value.
Index
mA Input
Related
Range: 0.000 ... 24.00 mA
8.7.2.9
Pump records (3.2.9.)
Identifies pump usage and if the associated Relay Function [Relay Function (2.8.1.4.)
(Page 195)] is set for any pump control feature. The value is that of the pump connected to
the associated terminals.
Enter a value to set the current record to that value. Use this if a pump is added with a
known number of hours logged, or the value can be reset to 0 after maintenance.
Relay selector (3.2.9.1.)
Sets the relay index for all parameters applicable to this sub-menu.
Pump hours (3.2.9.2.)
Sets or shows the total running time of the selected relay, in hours.
Range: 0 ... 999999
Pump run time (3.2.9.3.)
Sets or shows the total running time of the selected relay, in hours.
Range: 0 ... 999999
Pump starts (3.2.9.4.)
Shows or resets the accumulated number of times the selected relay has been ON.
Index
Relay
Values
Range: 0 ... 9999
Related
Relay function (2.8.1.4.) (Page 195)
To change the relay assignment, see Relay selector (3.2.9.1.) (Page 260).
Pump run-ONs (3.2.9.5.)
Shows or resets the accumulated number of times the selected relay has been held ON via
Run-ON Interval (2.8.2.7.1.) (Page 205).
Index
Relay
Values
Range: 0 ... 9999
Related
Relay function (2.8.1.4.) (Page 195)