Siemens HydroRanger 200 HMI - PROGRAM mode

Commissioning
6.4 PROGRAM mode
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
55
6.4
PROGRAM mode
The device is programmed by setting its parameters to match your specific application. Most
parameters are indexed, allowing you to set the parameter to specific conditions and to more
than one input or output. When the device is in PROGRAM mode, you can change these
parameter values and set operating conditions.
The device’s primary programming is through the four-button interface. For a full listing and
explanation of parameter values, see Parameter reference (Page 155).
6.4.1
Key functions in Measurement mode
Key
Function
Result
RIGHT arrow opens
PROGRAM mode
Opens the top level menu
LEFT arrow displays the next
Auxiliary Reading value in
Measurement View 2.
Scrolls through a list of available Auxiliary
Reading values, such as Distance, Tem-
perature, or Milliamp Output. For a com-
plete list, see
Default auxiliary reading
(2.12.7.) (Page 239).
UP or DOWN arrow toggles
between Measurement View
1 and Measurement
View 2
Local display shows Measurement View 1
or 2.
6.4.2
Programming the device
Note
•
To enter PROGRAM mode using the device buttons, press . Press repeatedly to
return to RUN mode.
•
While the device is in PROGRAM mode, outputs are de-activated and the device does
not measure the process.
Change parameter settings and set operating conditions to suit your specific application.