Siemens HydroRanger 200 HMI - Page 60

Commissioning
6.4 PROGRAM mode
HydroRanger 200 HMI
58 Operating Instructions, 06/2018, A5E36281317-AC
Changing a numeric value
1. Navigate to the desired parameter.
2. When selected, the current value is displayed.
3. Press
RIGHT
arrow to open
Edit
mode. The cursor position is highlighted.
4. Use
LEFT
and
RIGHT
arrow to move cursor to digit position you wish to change.
5. As each digit is highlighted (selected), use the
UP
and
DOWN
arrow to increase
or decrease the digit respectively.
6. While decimal point is selected, use
UP
and
DOWN
arrow to shift decimal
position.
7. To escape without saving your changes, press
LEFT
arrow continually until
ESC
is
highlighted. Press
LEFT
arrow again to escape without saving changes. Otherwise,
when new parameter value is correct, press
RIGHT
arrow continually until
OK
is
highlighted.
8. Press
RIGHT
arrow to accept the new value. The LCD returns to parameter view and
displays the new selection. Review for accuracy.
①
Parameter name
②
Parameter number
③ Current value