Siemens HydroRanger 200 HMI - Quick Start Wizards

Commissioning
6.5 Quick Start Wizards
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
59
6.4.4
Key functions in Edit mode
Key
Name
Function
UP
or
DOWN
arrow
Selecting op-
tions
Scrolls to item
Alpha-numeric
editing
• increments or decrements digits
• toggles plus and minus sign
RIGHT
arrow
Selecting op-
tions
• Accepts the data (writes the parameter)
• Changes from
Edit
to
Navigation
mode
Numeric edit-
ing
• Moves cursor one space to the right
• or, with selection highlighted, accepts the
data and changes from
Edit
to
Navigation
mode
LEFT
arrow Selecting op-
tions
Cancels Edit mode without changing the pa-
rameter
Numeric edit-
ing
• Moves cursor to plus/minus sign if this is
the first key pressed
• or, moves cursor one space to the left
• or, with cursor on Enter sign, cancels the
entry
6.5
Quick Start Wizards
Wizards provide step-by-step Quick Start (QS) procedures that configure the device for
simple applications. To configure the device for applications of Level, Volume (standard
vessel shapes), or Flow, see Setting wizards via graphical display (Page 60).
Wizards for applications employing more complex vessel shapes are available via SIMATIC
PDM. For more details, see SIMATIC Process Device Manager (PDM) (Page 327).
Before initiating a Quick Start Wizard to configure the device, you may wish to gather the
necessary parameter values. Parameter Configuration Charts that list all parameters and
available options for each application type are available at
www.siemens.com/processautomation
(https://www.industry.siemens.com/topics/global/en/process-automation/pages/default.aspx
).
You can record data and select from options on the chart that apply to your application, then
with this data on hand, complete the
Setting wizards via graphical display (Page 60) below,
or via another Quick Start Wizard, as referenced above.