Siemens HydroRanger 200 HMI - Page 64

Commissioning
6.5 Quick Start Wizards
HydroRanger 200 HMI
62 Operating Instructions, 06/2018, A5E36281317-AC
Start of Quick Start Level wizard
Shows the type of Wizard to be executed.
Options
CANCEL
START
Measurement point selector
Selects the measurement points to configure.
Note
This is available
on the dual-point model only.
Options
Point 1
Point 2
Point 3
Transducer
Specifies the model of the Siemens transducer connected to the device.
Index
Single-point model
Dual-point model
Global
Transducer
Options
*No transducer (dual-point preset)
ST-25
ST-50
STH
XCT-8
*XPS-10 (single-point preset)
XCT-12
XPS-15
XRS-5
mA input