Siemens HydroRanger 200 HMI - Page 76

Commissioning
6.5 Quick Start Wizards
HydroRanger 200 HMI
74 Operating Instructions, 06/2018, A5E36281317-AC
Start of Quick Start Flow wizard
Shows the type of Wizard to be executed.
Options
CANCEL
START
Measurement point selector
Selects the measurement points to configure.
Note
This is available on the dual
-point model only.
Options
Point 1
Point 2
Transducer
Specifies the model of the Siemens transducer connected to the device.
Index
Single-point model
Dual-point model
Global
Transducer
Options
*No transducer (dual-point preset)
ST-25
ST-50
STH
XCT-8
*XPS-10 (single-point preset)
XCT-12
XPS-15
XRS-5
mA input