Siemens HydroRanger 200 - Parameter Reference; Hydroranger 200 - 1, 3, or 6 Relay Models; Helpful Hints

7ML19985FC03 HydroRanger 200 – INSTRUCTION MANUAL Page 115
mmmmm
Parameters
Parameter Reference
The HydroRanger 200 is configured through its parameters, and the application
determines the parameter values which are entered into the unit.
Please check your value entries carefully before operating the HydroRanger 200 to
ensure optimum performance.
HydroRanger 200 - 1, 3, or 6 relay models
All HydroRanger 200 parameters are listed in this section. Parameters for the
HydroRanger 200, 6 relay model, are identified separately. The parameter title includes
this marking [6 relay model], indicating that parameter applies to the HydroRanger 200
6 relay model only.
As a general rule, parameters affecting volume, open channel flow or differential level
apply only to the HydroRanger 200 6 relay model.
Helpful Hints
Please note the following:
• Default values are always indicated with an asterix (*)
• Global values are common for all inputs and outputs on the unit
• Indexed parameters can apply to more than one input or output
• Primary index relates to an input or output
• Secondary index allows for multiple values on an indexed point
Accessing a Secondary Index
1. Press MODE , and then press DISPLAY to activate secondary index.
The icon appears under the index field.
2. Enter the secondary index, and then enter the values to set the secondary index.