7ML19985FC03 HydroRanger 200 – INSTRUCTION MANUAL Page 11
mmmmm
Installation
Panel Mount
Installing the panel mount unit requires making a cutout in the panel. The dimensions for
the cutout are provided in the illustration below. A full size cutout template is provided
with your unit or may be downloaded from www.siemens.com/processautomation
.
Cutout Dimensions
Cutout Instructions
1. Select a place for the unit and fasten the template onto the panel (use tape or
tacks).
2. Drill the four fastener holes.
3. Make the cutout using the appropriate tools.
4. Mount unit according to the instructions in this manual.
To Next Page
Loading...
