INHAB™ ENERGY INSTALLATION GUIDE
Step 3: Find a place
for the monitor
Locate a place within the electrical panel for the Inhab Energy monitor ensuring it is
at least .mm ( in) from any live parts including primary conductors, primary
terminals, and primary lugs; but excluding insulated cables. The breaker box may be
oriented differently than below, but the monitor is small and designed to fit easily
in the box. Find a place that works. If the Inhab Energy is to be mounted on a DIN
rail, the monitor has two threaded screw holes to attach mounting hardware using
two M screws and lock washers (sold seperately).
Energized
service
mains
DANGER
Hazardous Voltage
Will cause death or serious injury.
Turn off and lock out all power supplying this device before working on
this device. Replace all covers before power supplying this device is
turned on.
To Next Page
Loading...
