INHAB™ ENERGY INSTALLATION GUIDE
Step 6: Plug in the
voltage sensing wire harness
Insert the .mm screw terminal plug of the power supply wiring harness with four
AWG wire leads into the port of the left side of the energy monitor until it clicks
into place securely. These wires can also be cut to length to reduce panel clutter.
The wire harness allows for single-phase power and three-phase voltage sensing:
Black (L) provides power and voltage sensing, White (N) connects to Neutral, and
Red (L) and Blue (L) provide voltage sensing only (if applicable).
L2 & L3
voltage
or neutral
N
neutral
L1
power &
voltage
To Next Page
Loading...
