INHAB™ ENERGY INSTALLATION GUIDE
Troubleshooting Tips
The Siemens app isn’t showing solar net metering or grid measurements from
the Inhab Energy.
• Ensure the Main CTs are clamped on the mains between the meter and
incoming leads from the solar inverter.
• Ensure all CTs are oriented as per the instructions. CTs are directional.
• Check that the appropriate wiring harness wires are attached to adjacent
breakers on different phases
• When configuring the Inhab Energy with the App, make sure that you
temporarily turn the solar off so it is not supplying power to the system. Try
running the configuration at night.
• When configuring the Inhab Energy with the App, make sure that there is a
discernible load on the system. Try turning on an oven, A/C, or dryer.
To Next Page
Loading...
