INHAB™ ENERGY INSTALLATION GUIDE
Before you get started
The Siemens Inhab Energy is installed in a home’s electrical panel. The main breaker
will need to be set to the off position, which will shut off all of the power in the
home. However, the service entrance wires to the load center will remain
energized and dangerous. The following may help with safe installation.
• Installation should be performed by a qualified personnel only such as a licensed
electrician or other qualified professional
• Install in accordance with the regional electrical code where it is being installed
• Ensure that the product specifications of the Inhab Energy are compatible with
the system and the panel type where it is being installed.
• Identify the location of service disconnect. It may be outside of the panel.
• Ensure the work environment is clean with additional lighting available.
• Identify empty breakers or breakers that can be tapped for voltage monitoring.
The number required corresponds to the system phases.
• The following items are recommended:
Insulated gloves Protective eyewear
Alternative
light source
Phillips and flathead
screwdrivers
To Next Page
Loading...
