Siemens Inhab Energy - Energy Monitor Connections; Port Identification and Layout

INHAB™ ENERGY INSTALLATION GUIDE 
Energy monitor connections
The energy monitor is the hub of the Siemens Inhab Energy. The screw terminalport
for the wiring harness is located on the left-hand side of the monitor. The screw
terminal ports across the top of the monitor are the inputs for the A Branch
Current Transformers (CTs) (the bundle may have come with  or  CTs, or none at
all). The A, B, and C screw terminal ports on the right side of the monitor are the
inputs for the A Main CTs (the bundle may have shipped with two or three). The
RJ LAN port and coaxial connector for the WiFi antenna cable are also on the
right hand side of the monitor. All of the ports are clearly labeled on the energy
monitor.
WiFi
connector
RJ45
LAN port
top
frontleft
right
back
1 2 3 4 5 6 7 8 9 10 1112 13 14 15 16
50A CT 3.8mm screw terminal ports
200A CT screw
5mm terminal
ports (A,B,C)
Wiring harness
7.6mm screw
terminal port
M3 DIN rail mount
CAUTION / ATTENTION
Risk of electric shock
Review the installation guide.
Risque de choc electrique
Lisez le guide d'installation.
~100-240VAC L-N 1Ø/3Ø (Wye only)
50/60Hz, 0.041A, CAT III
Energy Monitor
E535044
IC: 28084-EMV3A
FCC ID:
2AS6P-EMV3A
Model: EMV3A
Inhab
TM
Energy | Model: INHEM100
3617 Parkway Ln, Peachtree Corners, GA 30092 | Made In India
RJ45
LAN port