Siemens iQ500 MB535A0 0B Series - Basic Operation; Switching On and Off; Setting Heating and Temperature

Basic operation en
11
4.
Set the type of heating and temperature.
→"Basic operation", Page11
Main oven ⁠ Top oven ⁠
Type of
heating
3Dhot air ⁠ Top/bottom
heating ⁠
Temperat-
ure
Maximum 240°C
Cooking
time
1 hour 1 hour
5.
Switch off the appliance after the specified cooking
time.
6.
Wait until the cooking compartment has cooled
down.
7.
Clean the smooth surfaces with soapy water and a
dish cloth.
8.
Clean the accessories using soapy water and a dish
cloth or soft brush.
7 Basic operation
7.1 Switching on the appliance
▶
Turn the function selector to any position other than
the "Off" position ⁠.
a The appliance is switched on.
7.2 Switching off the appliance
▶
Turn the function selector to the "Off" position ⁠.
a The appliance is switched off.
7.3 Setting the type of heating and
temperature
1.
Use the function selector to set the type of heating.
2.
Use the temperature selector to set the temperature
or grill setting.
a The appliance starts heating after a few seconds.
3.
When your food is ready, switch off the appliance.
Tips
¡ The most suitable type of heating for your food can
be found in the description of the type of heating.
¡ You can also set a cooking time and end time on
the appliance.
→"Time-setting options", Page12
Changing the type of heating
You can change the type of heating at any time.
▶
Use the function selector to set the required type of
heating.
Changing the temperature
You can change the temperature at any time.
▶
Use the temperature selector to set the required
temperature.
8 Rapid heating
To save time, you can use rapid heating to shorten the
preheat time.
Only use rapid heat-up when a temperature of over
100°C has been set.
After rapid heating, it is best to use the following types
of heating:
¡ 3Dhot air ⁠
8.1 Setting rapid heating
To ensure an even cooking result, do not place the
food in the cooking compartment until rapid heating
has come to an end.
1.
Use the function selector to select rapid heating ⁠.
2.
Use the temperature selector to set the required
temperature.
a Rapid heating starts after a few seconds.
a When the rapid heating process ends, an audible
signal sounds and the heating indicator goes out.
3.
Use the function selector to set a suitable type of
heating.
4.
Place the food in the cooking compartment.