Siemens iQ700 CE732GX 1 Series - Information on display panel; Disposal; Disposing of old appliance

en Disposal
20
Fault Cause and troubleshooting
The appliance is not
working.
Malfunction
1.
Switch off the fuse in the fuse box.
2.
Switch the fuse back on after approx. 10seconds.
a If the fault was a one-off, the message disappears.
3.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page21
Microwave not work-
ing.
Door is not fully closed.
▶
Check whether food remains or foreign material are trapped in the door.
Food does not heat
up.
Demo mode is activated in the basic settings.
1.
Disconnect the appliance from power supply by briefly switching off the circuit breaker in
the fuse box.
2.
Go to the basic settings and deactivate Demo mode within the next 5minutes.
→Page16
The interior lighting is
not working.
Different causes are possible.
▶
Call
→"Customer Service", Page21.
Microwave mode is
cancelled.
Malfunction
1.
reset the appliance
‒ Press and hold  button for at least 10seconds.
‒ Or switch off the fuse in the fuse box. Switch the fuse back on after approx.
10seconds.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page21
Food takes longer
than usual to heat up.
The microwave power setting is set too low.
▶
Set a higher microwave power setting.
A larger amount than usual has been placed in the appliance.
▶
Set a longer cooking time.
You need double the time when you have double the amount.
The food is colder than usual.
▶
Turn or stir the food from time to time during cooking.
Time not displayed
when appliance
switched off
Display switches itself off after a short time.
No action required.
17.2 Information on display panel
Fault Cause and troubleshooting
Message showing "D"
or "E" appears in the
display.
Malfunction
1.
Reset appliance.
‒ Either press and hold for at least 6 seconds.
‒ Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a If the fault was a one-off, the message will disappear.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page21
Disposal
18 Disposal
18.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
▶
Dispose of the appliance in an environmentally
friendly manner.