Installation instructions en
31
21.6 Installing below a hob
If the appliance is installed below a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
The minimum worktop thickness is based on the re-
quired minimum clearance .
Hob type raised in
mm
flush in
mm
in
mm
Induction hob 40 41 5
Full-surface in-
duction hob
50 51 5
Gas hob 30 41 5
1
Electric hob 30 33 2
1
Observe different national installation instructions
for the hob.
Observe the installation instructions for the hob.
21.7 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
If the tall unit has another back panel in addition to the
element back panels, this must be removed.
Only install the appliance up to a height which allows
the accessory to be easily removed.
21.8 Installing two appliances on top of
each other
Your appliance can also be installed above or below
another appliance. Observe the installation dimensions
and the installation instructions when installing appli-
ances on top of each other.
To ventilate the appliances, the intermediate floor must
have a ventilation cut-out.
To ensure sufficient ventilation of the two appliances,
there must be a ventilation opening of at least 200cm²
in the plinth area. To do this, trim the base panel or fit
a ventilation grille.
Ensure that air exchange is guaranteed in accordance
with the diagram.
Only install appliances up to a height that allows the
accessory to be easily removed.
21.9 Combination with a warming drawer
First fit the warming drawer. Follow the installation in-
structions for the warming drawer.
Slide the appliance, on the warming drawer, into the fit-
ted cabinet. When sliding in the appliance, do not dam-
age the warming drawer's panel.
To Next Page
Loading...
