Troubleshooting en
35
Note:
Further information:
24.4 Attaching the pull-out rail
Note:The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer from
below behind the two guide rods for the required
shelf position and keep it horizontal.
2.
Guide the rail lengthways to the rear to the guide
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer to grip the ver-
tical rod.
3.
Press and hold PUSH and swing the pull-out rail
inwards until the retainer is attached in the
lower rod.
4.
Release the PUSH tab.
a The retainer clicks into place.
5.
Pull the pull-out rail out as far as it will go and slide
it back in.
Note:
Further information:
Troubleshooting
25 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING‒Risk of injury!
Improper repairs are dangerous.
▶ Repairs to the appliance should only be carried out
by trained specialist staff.
▶ If the appliance is defective, call Customer Service.
→"Customer Service", Page38
WARNING‒Risk of electric shock!
Improper repairs are dangerous.
▶ Repairs to the appliance should only be carried out
by trained specialist staff.
▶ Only use genuine spare parts when repairing the
appliance.
▶ If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
To Next Page
Loading...