en
27
Fault Possible cause Remedial action
Displays do not illuminate. Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
It is too cold in the cooling
compartment or the
hyperFresh compartment.
Increase the temperature in the cooling
compartment.
Increase the temperature in the hyperFresh
compartment.
The temperature in
the freezer compartment is
too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstacles.
Large quantities of fresh
food are being frozen.
Do not exceed max. freezing capacity.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is switched
on.
Press and hold the °C button and the setting
button @ for 5 seconds until a confirmation
tone sounds.
After a short time, check whether your
appliance is cooling.
The side panels of the
appliance are warm.
Pipes run into the side panels
which heat during the
cooling process.
That is normal behaviour for the appliance and
not a fault.
To Next Page
Loading...
