LOGO! manual
EWA 4NEB 712 6006-02
60
3.12.1 Removing the program module/card
You can change the program module/card when the power is on and
LOGO! is in RUN or the programming mode. However, please heed the
following warning:
!
Warning
Only use LOGO! 230 with the cover or the program module/
card inserted.
Do not put your finger or an object made of metal or any other
conductive material in the open shaft of the program module/
card.
The socket for the program module/card may be live if mis-
takes have been made with the wiring (L1 and N mixed up).
The program module/card should only be changed by a trained
technician.
Remove the program module/card as follows:
RC–0047
Programming LOGO!
To Next Page
Loading...
