Service and maintenance
9.2 Cleaning
CMK2000
78 Operating Instructions, 11/2015, A5E34877550B/001
The diagnostics page with the following display appears following logon:
Image 9-1 Example of a diagnostics page
The LEDs shown in the picture correspond to the states described in section Status LEDs
(Page 22).
If an error has occurred, you can obtain further information on the error codes from Support
(http://support.automation.siemens.com
).
The LED displays may show the current state with a delay depending on the status of the
browser and the connection.
The displayed diagnostics information may vary between different firmware versions.
You can trigger updating of the device using the selection "Firmware update".
The corresponding files and instructions for updating the firmware can be obtained at
http://www.siemens.com/gamma-fdt.
To Next Page
Loading...
