Siemens LOGO!Power 6EP1311-1SH13 - Page 30

Technical data
6.2 Output
LOGO!Power
30 Operating Instructions, 06.2014, C98130-A7560-A999-3-7629
6EP1352-1SH03
(15 V / 4 A)
6EP1331-1SH03
(24 V / 1.3 A)
6EP1332-1SH43
(24 V / 2.5 A)
6EP1332-1SH52
(24 V / 4 A)
Output
Regulated, isolated DC voltage
Rated voltage value
Ua rated DC
15 V 24 V 24 V 24 V
Total tolerance, static ±
3%
3%
3%
3%
Static line regulation,
approx.
0.1% 0.1% 0.1% 0.1%
Static load regulation,
approx.
1.5% 1.5% 1.5% 1.5%
Residual ripple peak-
peak, max.
200 mV 200 mV 200 mV 200 mV
Residual ripple peak-
peak, typ.
10 mV 10 mV 10 mV 30 mV
Spikes peak-peak,
max. (bandwidth,
approx. 20 MHz)
300 mV 300 mV 300 mV 300 mV
Spikes peak-peak, typ.
(bandwidth, approx.
20 MHz)
70 mV 20 mV 50 mV 60 mV
Setting range
10.5...16.1 V
22.2...26.4 V
22.2...26.4 V
22.2...26.4 V
Product function /
output voltage can be
adjusted
Yes
Output voltage setting
Using a potentiometer
Status display
Green LED for output voltage OK
Response when
switching on/off
No overshoot of Ua (soft start)
Starting delay, max.
0.5 s
0.5 s
0.5 s
0.5 s
Voltage rise, typ.
15 ms
15 ms
10 ms
15 ms
Rated current Ia rated
4 A
1.3 A
2.5 A
4 A
Current range
• Remark
0…4 A
4 A to +55° C,
2.8 A to +70° C
0…1.3 A
1.3 A to +55° C,
0.9 A to +70° C
0…2.5 A
2.5 A to +55° C,
1.7 A to +70° C
0…4 A
4 A to +55° C,
2.8 A to +70° C
Output active power /
typical
50 W 30 W 60 W 96 W
Can be connected in
parallel to increase the
power rating
Yes
Number of devices
that can be connected
in parallel to increase
the power rating, units
2
Output characteristic
See Figure 6-3 Output characteristic (Page 31)