Siemens LOGO! Series - Page 117

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
117
LOGO! shows the following display:


2II
6\QF
2II
!2Q
The current setting of the automatic synchronization function is displayed on the bottom row.
The default setting is "
④"; that is, disabled.
T
o enable/disable synchronization in parameter assignment mode:

3UJ1DPH
6HW
6HW3DUDP
!6WRS

%0$,180
0HQX/DQJ
/&'
!&ORFN
If you want to enable/disable automatic synchronization in parameter assignment mode,
select "
⑥" in the parameter assignment menu , then menus "⑦" and "③". You can now
enable/disable automatic synchronization.
Enabling synchronization
You want to enable synchronization:
1. Move the '>' cursor to "
⑤": Press or
2. Confirm "
⑤"': Press OK
LOGO! shows the following display:
2Q
6\QF
2II
!2Q