Siemens LOGO! Series - Page 238

LOGO! functions
4.4 Special functions list - SF
LOGO!
238 Manual, 04/2011, A5E03556174-01
Input P configuration
From the input P, you configure the following characteristics of the message text:
● Priority
● Acknowledgement
● Message destination
● Tick type, and tick setting for each line
To configure the priority and the acknowledgment (programming mode):

%
$FN 2II
3ULRULW\
PHDQV7KHSDUDPHWHUVDQGDFWXDOYDOXHVLQ
DQDFWLYHPHVVDJHWH[WFDQEHHGLWHG
6WDWXVRIWKHDFNQRZOHGJHPHQW
3ULRULW\
1. Increase the priority to 1: Cursor on '0' +
2. Change to 'Ack': Press
3. Enable 'Ack': Press
or
LOGO! shows:

%
$FN 2Q
3ULRULW\
6WDWXVRIWKHDFNQRZOHGJHPHQWಯ2Qರ
3ULRULW\
To configure the message destination and tick type (programming mode):
1. From the Priority and Acknowledgement screen form, press
to access the Message
Destination screen form.
%0
%
0VJ'HVW
0HVVDJH'HVWLQDWLRQ/2*2%DVLF
PRGXOH/2*27'RUERWK
2. Press
to position the cursor on the "BM" line.
3. Press
or to toggle through the three choices for message destination: BM, TD, or BM
& TD.
4. From the Message Destination screen form, press
to access the Tick Type screen
form.
&KE\&K
%
7LFN7\SH
7LFN7\SH&KDUDFWHUE\&KDUDFWHU&K
E\&KRU/LQHE\/LQH/QE\/Q