Applicable cards
8.4 Copying data from the card to LOGO!
LOGO!
312 Manual, 04/2011, A5E03556174-01
Copying by means of the "Card" menu
For information on the replacement of a memory card, combined memory/battery card, or an
SD card, also note the information in the topic "Inserting and removing the card from LOGO!
(Page 307)".
To c
opy
a program from the card to LOGO!:
1. Insert the card
2. Switch LOGO! to programming mode (ESC / >Stop).
6WDUW
6HWXS
&DUG
!3URJUDP
3. Move the '>' cursor to 'Card': Press
or
4. Press OK. The transfer menu opens.
5. Move the '>' cursor to 'Card → LOGO': Press
or
/2*2
&RS\3URWHFW
!&DUG
ൺ&DUG
6. Press OK.
LOGO! copies the circuit program from the card to LOGO!. (If the card is from an
incompatible 0BA0..0BA3 version, LOGO! displays this message: "Unknown Card / Press
ESC".)
When LOGO! has finished copying, it automatically returns to the main menu.
To Next Page
Loading...
