en Installation instructions
18
8.
Screw the nuts approx.10mm onto the threaded
rods.
Preparing the appliance
1.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
2.
Loosen the screws on the side covers.
3.
Open the odour filter cartridge.
4.
Push the side covers inwards and remove them.
5.
Close the odour filter cartridge.
Hanging the appliance
1.
Lift the appliance by the corners and turn it over.
2.
Position the cable that is provided on-site in the
marked area on the appliance.
3.
Guide the cable that is provided on-site through the
opening and hook the appliance into the fastening
screws on the ceiling.
4.
Push the appliance as far as it will go into the four
key hole openings using the guide sleeves.
To Next Page
Loading...
