en Installation instructions
18
6.
Hook the motor block into the central screw and
tighten the screw.
7.
Tighten the second central screw.
8.
Screw in the remaining four screws loosely; do not
tighten them fully.
9.
Loosen the two central screws again.
10.
Align the motor block and tighten all of the screws.
11.
Connect the exhaust air pipe.
12.
Fit the air pipe connector.
13.
Insert the power cable into the motor.
14.
Insert the motor into the motor block and screw it
in tightly .
To Next Page
Loading...
