Installation instructions en
21
1.
Tilt the transport lock slightly upwards and carefully
pull it upwards and out at an angle.
2.
Remove polystyrene residues from the interior of the
appliance.
3.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
Installing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
1.
Insert the appliance into the cut-out until you hear
the mounting brackets engage.
2.
Carefully screw in diagonally opposite screws.
Tighten the screws one at a time so that the appli-
ance is not wedged in the cut-out.
3.
Note:To ensure that the appliance is not damaged,
do not overtighten the screws.
Carefully tighten screws in succession until the ap-
pliance is flush-mounted on the ceiling.
Connecting the appliance
1.
Press together the cable duct at the sides and re-
move it.
2.
Disconnect the cable at the appropriate point.
3.
Undo the opposite screws to loosen the fan box.
To Next Page
Loading...
Need help?
General
