Installation 5 - 17
Siemens AG SPB7-230.814.01 Page 17 of 24 Opdima
Medical Solutions Rev. 01 10.04 CS PS 24 Installation
Strain relieving the cables 5
If the workstation table (option) is used with the Opdima system, the cables from the
workstation components and from the MAMMOMAT must be strain relieved by cable
clamps at the back of the MO unit shelf according to the figure below.
• To ensure that the cables have enough length for the vertical adjustment, let the
workstation table be in its highest possible position when strain relieving the cables.
• Use cable ties to arrange the cables in an organized way and make sure that the cables
can run without a risk of getting caught.
Fig. 19
Opd00630
A
1
BCDEFGH
0
SCSI CONNECTOR
AC IN
F.GND
SCSI ID
MO AC
Printer/
Biopsy
controller
WS Mains
power supply
Camera
controller
Network
connector
power
To Next Page
Loading...
