PXCM Web Tool February 5, 2004 5-19
To upgrade the MCB firmware:
1. Click the Upgrade Firmware button on the MCB page.
The Upgrade PXCM Firmware (MCB) page displays.
2. Click the Browse button, then navigate to and select the appropriate MCB
firmware file from your Acquisition Workstation’s file system.
The file you selected is displayed in the Please select the Firmware file to
transfer field
NOTE: To clear your file selection, click the Reset Form button.
3. When you are ready to start the firmware file transfer, click the Upgrade Now
button.
The file transfer status is displayed on the page.
4. After the transfer is complete, reboot the PXCM to have it start up using the
firmware you just transferred. For information, refer to “Rebooting the PXCM”
on page 5-21.
CAUTION
The PXCM Web Tool does not check that the appropriate file type has been
selected. If you select the wrong file to upload, you could cause the PXCM to stop
operating.
To Next Page
Loading...
