5 System Parameters International English
MICROMASTER 440 Operating instructions
58 6SE6400-5CA00-0BP0
Analogue I/O (P0004 = 8)
Par. No. Parametername Default Acc WS QC
P0295 Inverter fan off delay time 0 3 CUT N
r0750 Number of ADCs - 3 - -
r0752[2] Act. input of ADC [V] or [mA] - 2 - -
P0753[2] Smooth time ADC 3 3 CUT N
r0754[2] Act. ADC value after scaling [%] - 2 - -
r0755[2] CO: Act. ADC after scal. [4000h] - 2 - -
P0756[2] Type of ADC 0 2 CT N
P0757[2] Value x1 of ADC scaling [V / mA] 0 2 CUT N
P0758[2] Value y1 of ADC scaling 0.0 2 CUT N
P0759[2] Value x2 of ADC scaling [V / mA] 10 2 CUT N
P0760[2] Value y2 of ADC scaling 100.0 2 CUT N
P0761[2] Width of ADC deadband [V / mA] 0 2 CUT N
P0762[2] Delay for loss of signal action 10 3 CUT N
r0770 Number of DACs - 3 - -
P0771[2] CI: DAC 21:0 2 CUT N
P0773[2] Smooth time DAC 2 3 CUT N
r0774[2] Act. DAC value [V] or [mA] - 2 - -
P0777[2] Value x1 of DAC scaling 0.0 2 CUT N
P0778[2] Value y1 of DAC scaling 0 2 CUT N
P0779[2] Value x2 of DAC scaling 100.0 2 CUT N
P0780[2] Value y2 of DAC scaling 20 2 CUT N
P0781[2] Width of DAC deadband 0 2 CUT N
Setpoint Channel and Ramp Generator (P0004 = 10)
Par. No. Parametername Default Acc WS QC
P1000[3] Selection of frequency setpoint 2 1 CT Q
P1001[3] Fixed frequency 1 0.00 2 CUT N
P1002[3] Fixed frequency 2 5.00 2 CUT N
P1003[3] Fixed frequency 3 10.00 2 CUT N
P1004[3] Fixed frequency 4 15.00 2 CUT N
P1005[3] Fixed frequency 5 20.00 2 CUT N
P1006[3] Fixed frequency 6 25.00 2 CUT N
P1007[3] Fixed frequency 7 30.00 2 CUT N
P1008[3] Fixed frequency 8 35.00 2 CUT N
P1009[3] Fixed frequency 9 40.00 2 CUT N
P1010[3] Fixed frequency 10 45.00 2 CUT N
P1011[3] Fixed frequency 11 50.00 2 CUT N
P1012[3] Fixed frequency 12 55.00 2 CUT N
P1013[3] Fixed frequency 13 60.00 2 CUT N
P1014[3] Fixed frequency 14 65.00 2 CUT N
P1015[3] Fixed frequency 15 65.00 2 CUT N
P1016 Fixed frequency mode - Bit 0 1 3 CT N
P1017 Fixed frequency mode - Bit 1 1 3 CT N
http://nicontrols.com
To Next Page
Loading...
