Siemens MILKPERFECT EQ-5 - Page 38

38
en
Problem Cause Remedy
Coffeeistoo“bitter”. Thegrindsettingistoone
orthepregroundcoffeeis
toone.
Adjustthegrindingunitto
acoarsersettingoruse
coarserpregroundcoffee.
Unsuitabletypeofcoffee. Changethetypeofcoffee.
Thewaterlterdoesnot
stayinpositioninthewater
tank(16).
Thewaterlterisnottted
correctly.
Firmlypressthewaterlter
straightdownintothetank
connection.
Thecoffeegroundsarenot
compactandaretoowet.
Thegrindsettingistoone
ortoocoarse,ornotenough
groundcoffeehasbeen
used.
Adjustthegrindingunitto
acoarserornersetting,
oruse2levelmeasuring
spoonsofgroundcoffee.
LED
Dlightsup
Watertankhasbeen
incorrectlyinsertedorthe
newwaterlterhasnot
beenrinsedaccordingto
instructions.
Insertthewatertank
correctlyorrinsethewater
lteraccordingtoinstruc
tionsandthenswitchon.
LED
Iashes.
Brewingunit(5)issoiled. Cleanthebrewingunit(5).
Toomuchpregroundcoffee
inthebrewingunit(5).
Cleanthebrewingunit(5)
(Putinnomorethan2level
measuringspoonsofground
coffee).
Thebrewingunit
mechanismisstiff.
Removeandcleanthe
brewingunit,see“Mainte
nanceanddailycleaning”.
Coffeeormilkfrothquality
varieswidely.
Buildupoflimescaleinthe
appliance.
Descaletheappliancewith
twodescalingtabletsasde
scribedintheinstructions.
Waterdrippedontothein
nerooroftheappliance
whenthedriptray(8)was
removed.
Driptray(8)removedtoo
soon.
Waitafewsecondsafter
thelastdrinkwasdispensed
beforeremovingthedrip
tray(8).
LED
Ilightsup.
Brewingunit(5)ismissing
orhasnotbeendetected.
Switchofftheappliance
withthebrewingunit(5)in
place,waitthreeseconds
andswitchontheappliance
again.
Ifyouareunabletosolvetheproblem,pleasecallthehotline.
Youwillndthetelephonenumbersatthebackoftheseinstructions.
Simpletroubleshooting