Siemens Milltronics BW500/L - Milltronics BW500 and BW500;L

BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD
13
The Manual
2
Note
•
The Milltronics BW500 and BW500/L are to be used only in the manner outlined in this
instruction manual.
•
These products are intended for use in industrial areas. Operation of this equipment in a
residential area may cause interference to several frequency based communications.
This instruction manual covers the operation, installation, and maintenance of Milltronics BW500
and BW500/L.
Please refer to this manual for proper installation and operation of your BW500 or BW500/L belt
scale integrator. As BW500 and BW500/L must be connected to a belt scale, and optionally a
speed sensor, refer to their manuals as well.
The manual is designed to help you get the most out of your BW500 and BW500/L, and it
provides information on the following:
•
How to install the unit
•
Outline diagrams
•
How to program the unit
•
Wiring diagrams
•
How to operate the keypad and read the display
•
Parameter values
•
How to do an initial Start Up
•
Parameter uses
•
How to optimize and maintain accurate operation of
the unit
•
MODBUS register mapping
•
Modem configuration
We always welcome suggestions and comments about manual content, design, and
accessibility. Please direct your comments to
techpubs.smpi@siemens.com
.
For the complete library of Siemens Milltronics manuals, go to Siemens Milltronics manuals
(www.siemens.com/weighing
).