Siemens Milltronics BW500/L - LVDT Conditioner Card

Installation
5.3 Optional Plug-ins
BW500 and BW500/L
26 Operating Instructions, 12/2016, A5E33482052-AD
BW500 may be shipped to you without an mA I/O board, for installation at a later date.
If you are ready to install your mA I/O board, please follow the instructions as outlined.
Installation
1. Isolate power and voltages applied to the BW500
2. Open the lid
3. Install the board by mating the connectors and secure the card in place using the three
screws provided
4. Close the lid
5. Apply power and voltage to the BW500
Refer to
● Specifications (Page 17)
● mA I/O Board Connections (Page 43)
●
mA I/O Parameters (P200 - P220) under mA I/O Parameters (P200 - P220) (Page 161)
● mA I/O (0/4-20 mA) in the mA I/O (0/4-20 mA) (Page 101) section.
5.3.3
LVDT Conditioner Card
BW500 is software/hardware ready to accept the optional LVDT conditioner card.
BW500 may be shipped to you without an LVDT conditioner card, for installation at a later date.
If you are ready to install your card, please follow the instructions as outlined.
Installation
1. Isolate power and voltages applied to the BW500
2. Open the lid
3. Install the three provided standoffs into the motherboard at the locations as shown in the
diagram in Layout.
4. Connect the wiring between the card and the motherboard according to the instructions in
Scale – LVDT.
5. Affix the card on the standoffs using the three screws provided.
6. Close and secure the lid.
7. Re-apply power and voltages to the the BW500.
Refer to
● Specifications (Page 17)
● Scale – LVDT (Page 34)