Siemens Milltronics BW500/L - Page 52

Start Up
6.2 Program Mode
BW500 and BW500/L
50 Operating Instructions, 12/2016, A5E33482052-AD
Or press the following for the direct access of parameters:
P940-2 Load Cell mV Signal Test
mV reading for B
V
6.78
For example: access P940-2, load cell B mV signal
To change a parameter value
P011 Design Rate:
Enter Rate
V
100.00 kg/h
From the view mode
Press the following key:
P011 Design Rate:
Enter Rate
E
100.00 kg/h
If edit mode is not enabled after pressing ENTER, security is locked. Refer toSecurityLock (P000)
under Parameters for instructions on disabling.
Press the following key to enter the new value
P014 Design Speed
Enter Speed
V
0.08 m/s
For P001 to P017, ENTER effects the change and scrolls to the next required parameter.