Siemens AG SPR8-230.831.30.03.02 MOBILETT XP Digital
11.05 CS SD 24
General maintenance information 31
Page 31 of 74
Medical Solutions
2.10 Technical Safety Checks (TSC)
Abbreviation: TSC = Technical Safety Checks
NOTE
Within the purview of DIN VDE 0751-1, the operator of medical en-
gineering products has to perform technical safety checks at reg-
ular intervals.
The checks listed in these maintenance instructions include all
technical safety checks required by DIN VDE 0751-1.
A separate protocol with the print number SP00.000.834.01... is
available for each technical safety check.
Within the purview of DIN VDE 0751-1, we recommend document-
ing the maintenance results both in the maintenance protocol and
in the TSC protocol. The protocols should be filled out completely
and handed over to the client after maintenance is complete.
The table below assigns each technical safety check listed in doc-
ument SP00.000.834.01... to the corresponding maintenance work.
Test report/
Technical safety checks
Maintenance instructions for the
check/comments
1. Identification data n.a.
2. General checks n.a.
2.1 Visual inspection: Is there any dam-
age affecting safety?
3.1.1 Damage, checks:
SIM Covers
SIM Detector/cassette holder
SIM Control and display panel
SIM Release cable
SIM Single tank
SIM Collimator
2.2 Are all cables and cable guides
secure and without any visible damage?
3.2.9 Power cable, checks:
SIM Power cable check
SIM General cable winch information
3.2.9.1 Power plug, check:
SIM Power plug check
3.2.7.5 Cable harness for the arm system,
check:
SIM Damage-free
To Next Page
Loading...
