Installing and Starting the Ethernet CP with STEP 7
61
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Procedure
To enter a substitute object in the project, following the steps below:
1. Select the project in the SIMATIC Manager.
2. Select the menu command Insert
"
Station
"
and then as necessary
Other Station, PG/PC or SIMATIC S5.
Possible result: the selected object is created in the project.
Figure 2-6 Project With Substitute Objects Configured
Attaching Non-S7 Stations to the Subnet
The next step is to assign the substitute objects to the subnet, as follows:
1. Select the required object in the project and select Edit
"
Object Properties.
2. In the Properties dialog box that is displayed select the ”Interfaces” tab and
click the “New” button (for example “Other Station”.
Result: The New Interface – Type Selection dialog box is displayed.
To Next Page
Loading...
