Installing and Starting the Ethernet CP with STEP 7
62
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Figure 2-7 Selecting the Subnet Type for “Other Station” (Example)
3. Select a subnet.
Result: The “Properties – Ethernet Interface” dialog is displayed. Here, you can
select the subnet, connect the station to the network and set the address (MAC,
IP). All the SIMATIC stations in the project can establish communication
relationships to this substitute object.
The addresses (MAP/IP) configured for the substitute object here must also be set
on the station using the appropriate tool, for example COM 1430.
To Next Page
Loading...
