Siemens OpenStage 60 - Team Call Features - Trunk Key Operations; Answering and Dialing with Trunk Keys; Placing Calls on Hold and Retrieving Them via Trunk Keys

Making calls in the team/executive/secretary configuration
141
Step by Step
Answering calls with the trunk keys
Prerequisite: You can see an incoming call on a trunk.
if nec.
T Press the trunk key that is flashing quickly
(only if Prime Line Æ page 140 is not active).
^ Lift the handset.
or Speakerphone mode.
Dialing with trunk keys
if nec. S Select a line (only if Prime Line Æ page 140 is not ac-
tive).
j Enter the station number.
^ Lift the handset.
or Speakerphone mode.
Placing a call on hold on a trunk key and
retrieving the held call
Prerequisite: You are conducting a call via one of your
group’s trunks. The "Hold" key has been programmed
on your telephone Æ page 89.
Hold
S Press the "Hold" key.
if nec.
\ or s Replace the handset or press the key shown.
Depending on the configuration (contact your service
personnel), this may be necessary so other team mem-
bers can also pick up the call on hold.
Retrieving the call
T Press the trunk key flashing slowly.