2)
Explanation in the following table. When making the settings via the 3RW5 HMI High Feature, observe the Equipment Manual
of the 3RW5 soft starter. You can select the parameter set directly in the SIRIUS Soft Starter ES (TIA Portal).
Additional information
The following table describes the assignment of the substitute values "Parameter set bit 0" and
"Parameter set bit 1":
Parameter set Parameter set bit 0 Parameter set bit 1
Process image error 1 1
Parameter set 1 (PS1) 0 0
Parameter set 2 (PS2) 1 0
Parameter set 3 (PS3) 0 1
Conguring
6.3 Operation on failure of the bus connection to the controller
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 67
To Next Page
Loading...
