[sc_resetflags, 1, en_US]
Figure 2-8
Reset Flags
Reset using ▶ key (TEST/RESET key)
From the Relay Identifier screen, reset the LEDs and outputs by pressing the ▶ key (TEST/RESET key).
Reset through Rear Communication Protocol
The resetting of LEDs and BOs is possible via the rear communication protocol like Modbus RTU and
IEC 60870-5-103.
Device Functionality
2.8 Resetting of LEDs, Trip Flag Indication, and Binary Outputs
32 Reyrolle, 7SR46 Device, Manual
C53000-G7040-C103-1, Edition 10.2022
To Next Page
Loading...
